Browse products and models
Street Light Controller
CX-NEMA Lamp Controller
- Communication
- Zigbee mesh (2.4 GHz)
- Connection
- NEMA socket (ANSI C136.41)
- Ingress protection
- IP65
Product features
Connected Control for Individual Street Lights
- NEMA socket connection compliant with ANSI C136.41.
- Zigbee mesh communication with self-networking and self-healing.
- Remote ON/OFF control and compatible 0-10V or PWM dimming.
- Real-time luminaire status, electrical data and fault monitoring.
- Automatic operation using schedules, optional light sensing and adaptive strategies.
- Power-loss detection and active fault reporting.
- AES 128-bit communication encryption and remote firmware upgrades.
- Optional tilt sensor, GPS and light sensor configurations.
- High-accuracy RTC for local scheduled operation.
Technical data
Product Parameters
| Parameter | Specification |
|---|---|
| Model | DYSLC12-Z |
| Dimming interface | 0-10V / PWM |
| Power outage detection and reporting | Supported |
| Remote control | ON / OFF / Dimming |
| Power supply | 85-265 V AC / 50-60 Hz |
| Maximum power consumption | < 3 W |
| Load rating | 5 A / 250 V AC |
| Measurement accuracy | +/- 2% |
| Communication network | Zigbee mesh network |
| Communication frequency | 2.4 GHz |
| Communication security | AES 128-bit |
| Operating temperature | -30 C to 70 C |
| Operating humidity | <= 95% RH at 25 C |
| Ingress protection | IP65 |
| EMC compatibility | Level 3 |
| Dimensions | Diameter 85 x 100 mm |
| Weight | 250 g |
Installation instructions
Installation and Wiring
- Disconnect and verify the absence of electrical power before installation.
- Confirm that the luminaire receptacle, supply voltage, load and dimming interface match the approved controller configuration.
- Align the NEMA contacts, push the controller down and twist it into the locked position. Reverse the action to remove it.
- Restore power only after the controller is fully seated and the luminaire ingress protection is maintained.
- Commission the controller in the management platform and verify switching, dimming, data and alarm reporting.
| Pin ID | Pin Description | Function Definition | Remark |
|---|---|---|---|
| N | AC power input/output | Power input neutral line | AC 220 V |
| Li | AC power input/output | Power input live wire | AC 220 V |
| Lo | AC power input/output | Power output live wire | AC 220 V |
| Minus | Port | DALI- / 0 V | Same as pin 3 |
| Plus | Port | DALI+ / 10 V | Same as pin 4 |
| 3 | Port | DALI- / 0 V | |
| 4 | Port | DALI+ / 10 V |
Safety: Installation and maintenance must be completed by qualified personnel with electrical power isolated. Follow the approved model-specific manual and applicable local electrical regulations.